Book a site visit

Case studies

Compressed air case studies

3 of our 19 case studies are about compressed air.

All 19 case studies

This is a real page with its own address, not a JavaScript filter state (§B.2). Combining two rails is a URL parameter on the library page.

What we found.

  • Compressed airWaterFood & Beverage ProcessingBulk Handling & Rail Logistics

    More than 450,000 litres saved in four months

    PDI Bulk

    PDI Bulk saved more than 450,000 litres of water in four months and produced a clear before-and-after view of compressor performance.

    >450,000 Lin 4 months

  • Compressed airManufacturing: Automotive, Plastics & RubberMetal Fabrication & Finishing

    Compressed air leaks in a stamping operation

    A Tier 2 automotive stamping factory

    Permanent monitoring revealed compressed air continuing to flow into an otherwise idle building overnight.

    20–30%of compressor output

  • Compressed airNatural gasMetal Fabrication & FinishingBuilding Materials, Concrete & Aggregates

    A furnace over-cycling, seen on the air and gas traces together

    A heat-treating operation

    Short-cycling that neither the gas bill nor the air system showed alone.

    2 utilitieson one chart

Run the same numbers on your own factory.

The estimator on our ROI page reads your own bills against our published benchmarks and gives you a sense of what is probably hiding in yours. It takes about a minute.

Book a site visitOpen the compressed air calculator

or call 1-833-QUANTFY (1-833-782-6839)